Factory Floor Status
The Factory Floor Status consists of two reports: Factory Floor Status - Device list and Factory Floor Status - S7 MLFB overview.
The Factory Floor Status- Device list report presents an overview of the devices and technologies supported by versiondog in a table. A status is reported for each device based on the status of the monitoring tasks per device (also called device-specific monitors).
Image: Report Factory Floor Status - Device overview
The report Factory Floor Status - S7 MLFB overview shows a list of all assemblies that belong to an S7 controller. MLFB overview is also set up for SIMATIC S7-1200 and S7-1500. With this report, the user can see at a glance which firmware is installed on which device and if a firmware update is necessary.
Image: Report Factory Floor Status - S7 MLFB overview.
The Factory Floor Status is displayed and operated via the WebClient.
Feature overview
Status overview for all devices and technologies integrated into the versiondog system:
- Comparison results taken from of the most recently executed job
- Warning displayed if a backup is not made within a user-specified time period
Detailed view for S7 (S7-300, S7-400):
- Overview of MLFB incl. installed firmware
- Forced value monitoring
- Display of cycle time, memory, error collection, battery status (hardware dependent)
The Factory Floor Status cannot read out any details (e.g. the MLFB number) for ET200 devices.
Detailed view for other devices:
- Monitoring of forced values for RSLogix 5000, Emerson PAC Machine Edition
- Overview of SEW firmware
Support for TIA Portal with S7-1200 and S7-1500 controllers
- The data displayed in the Factory Floor Status is not real-time data. The data transfer occurs after each time an individual job is executed in the versiondog system.
- Only those devices for which a job also exists in versiondog are displayed and monitored in the Factory Floor Status.
- The information that appears in Factory Floor Status always reflects the last job execution. If no job has yet been executed, Factory Floor Status will not display any result.
- The data in the Factory Floor Status are determined and recorded independently of the storage strategy.
- For SINAMICS frequency inverters, the MLFB number is not read out.
Other special hardware or software is not required to use the Factory Floor Status. The standard hardware and software requirements apply for versiondog .
The Factory Floor Status is an add-on and must be enabled separately in your license. If you are interested in using the Factory Floor Status, please contact us (https://auvesy.com/en/contact
| Related topics |
|---|
| Hardware and software requirements |
| WebClient |
In this tutorial:
Last update: Last updated: 14 January 2022